when troubleshooting a computer, why might you have to enter BIOS setup? List three reasons
Looking in the BIOS setup is often a necessary part of troubleshooting a computer, since the information in there can be wrong. For instance, if the system doesn't recognize a hard drive, then it is possible that it is not enabled in the CMOS settings. At other times, the CPU or the memory could be clocked too fast and leading to crashes and errors.
If you're unable to enter the installer setup for the THR840D, first ensure that all connections are secure and that the device is powered on correctly. Try restarting the device and pressing the appropriate button or key combination during boot to access the setup. If the issue persists, consult the user manual for specific troubleshooting steps or contact customer support for assistance. Additionally, check for any firmware updates that might address this issue.
Configure security through the CMOS setup utility.
Run "time" command.. It will give you the current time and then you can enter your new time there..
The phrase "search for computer setup computer" suggests looking for information or resources related to setting up a computer, possibly focusing on the specific components or configurations needed. On the other hand, "setup" and "computer setup" typically refer to the process of arranging and configuring a computer system for use. The former emphasizes the inquiry aspect, while the latter two focus more on the act of establishing the computer's operational environment.
Generally, no, you cannot enter the CMOS setup after you have booted. But it depends on the exact computer and if there is a separate CMOS configuration tool. In fact, the IBM AT was like that, and it required a separate setup program that ran after the computer booted. Some of the modern computers will let you change certain CMOS settings on the fly if you install a utility their utility for doing that.
Type your answer here... how setup thinline
yes but it invloves using the BIOS. Do this at own risk! Shut down your computer then the first screen you see enter setup (usually f8) then use the arrow keys to navigate to boot device tab. Highlight the boot device you want press enter then esc then highlight save and exit and hit enter. Then once the computer restarts the computer should boot with the device you selected.
When you start a computer, you get a prompt that says something like "Hit F2 to enter Setup". In this case, Setup is the information stored in the BIOS, and is located on a chip on the motherboard called the CMOS. This contains all the most basic information needed to start up the computer and tell it where the memory, hard drives, processor, etc are in order to continue starting up.
You need to enter setup on bootup, and it will be displayed. When the computer boots up, it usually shows on the screen, if you can read it fast enough?
No, not all systems use the same method to enter CMOS setup. Some systems allow access to CMOS setup by pressing DEL during start up and others by pressing F2.
New iPads that come with iOS 5 do not require a computer to setup your iPad. If it's older than iOS 5 then yes you need a computer for setup.