mashallah
It's probably the switch.
It should be on either the pedal shaft or the pedal frame.
When the router wants to send traffic to an IP address across a Frame Relay link, it needs to tell the frame switch which PVC the traffic should traverse. A frame switch drops any traffic it receives that has no DLCI in the header, because it has no way of determining how to route the data.
Yes. 17 cm of rain is a deluge and would very likely cause flooding. Of course it depends on the time frame in which the 17 cm fell.
It depends on where the flooding is. If it is near the ocean and the flooding is from the ocean, then it would be salt water, If the flooding is from rainwater, It would be freshwater.
If the porch light switch is the only outside item controlled y the switch bank inside the house, the porch light switch should be located the furthest from the door frame adjacent to which the switch bank is sited. The switch closest to the door should control the lighting in the room immediately adjacent to the door. In this manner, when entering the room from the outside in the dark, you merely toggle the nearest switch to the door frame to light the room - you don't have to reach around or over other switches. Switches controlling other internal lights should be sited in between. So, for a 2-gang arrangement, the switch located closest to the door frame controls the interior light and the other switch controls the porch light. For a three-gang arrangement, the middle switch would control another interior light. The only complication is that is if there are switches in the switch bank that control other exterior circuits, the porch light would be inboard of these and would not be the last outboard switch in the array. So, for a three-gang array in which two exterior lights are switched, the porch light switch would be the middle switch and the other exterior lights (sports, floods, landscape lighting, etc.) would be controlled by switches placed further from the door frame.
Try pushing the turn signal lever forward, or pulling it toward you. This is a common location for the high beam switch.
yes, In BD more flooding
If there were no bogs flooding would be increased
the job of a forward is to shot that would be the small forward and the power forward would be to shot inside or to create space
to determine which ports are not correctly configured to prevent MAC address flooding
Yes, there should be, but it would vary depending on the security features of the switch port - google "switchport port-security" for examples. Once this is set, the switch won't forward packets to addresses outside of the specified range.