It should be Wireless, somewhere in Security for wireless networks.
You have to have a router capable of supporting WPA2 as well as a wireless adapter in your computer should support it too. If you are sure that you satisfy both, you need to log in your router, and in settings for wireless network security choose WPA2.
It's your network, and no one here has WEP codes for you. You need to examine the programming and documentation for your Netgear to discover the correct WEP settings for your Belkin card.
The WEP code, if enabled, can typically be found on the Xfinity router's settings page. To access it, connect to your network and enter "http://10.0.0.1" in a web browser. Log in with your admin credentials, then navigate to the "Wireless" settings section to view or change the WEP key. If you don't see WEP settings, it may be because the router is using a different security type, like WPA/WPA2.
You're referring to a WEP/WPA/WPA2 key. These aren't on your Xbox, they are actually Passwords for your router/wireless internet. You can get these from your network settings on your computer if using Windows 7, on the router itself, or if you have a Gateway, check the gateway or contact your Internet Service Provider.
WEP is the most basic and is easily broken by knowledgeable people. WPA2 is newer and is much more seure.
The two common encryption methods used in wireless networks are Wired Equivalent Privacy (WEP) and Wi-Fi Protected Access (WPA/WPA2). WEP was the original standard but is now considered insecure. WPA and WPA2 provide stronger encryption and are widely used to secure modern Wi-Fi networks.
It's very easy to secure a wireless router, but be sure to use WPA2 encryption, as WEP is very insecure.
The Nintendo DS Internet Connection Interface only allows WEP wireless network. You will have to change a few settings on your router to make this work.
The WEP (Wired Equivalent Privacy) code on an Arris router is the encryption key used to secure your wireless network. It is typically a 10 or 26 hexadecimal digit string, depending on whether you're using 64-bit or 128-bit WEP encryption. You can find this code in the router's settings interface, usually accessible via a web browser by entering the router's IP address. However, it's important to note that WEP is considered outdated and less secure compared to WPA or WPA2, so upgrading your security settings is recommended.
If its your router then you should have it. If you dont, you are going to have to login into the router and reset the WEP settings. If you have lost your router password aswell you will just have to reset the router and start from scratch.
Every router and access point have a way to reset it without software. Most routers have a small push button that you can press with a paper clip. It is router specific. It means that you will have to find manual for your access point to get specific instructions. Belkin website will have everything you need.
Yes. WEP is easily hackable.