0
On a Mercedes C280, Bank 2 Sensor 1, which is the upstream oxygen sensor, is located on the right side of the engine, before the catalytic converter. Typically, it's positioned on the exhaust manifold or close to it, making it accessible from underneath the vehicle. For precise location, it's advisable to consult the vehicle's service manual or a repair guide.
What else can I help you with?
Where are the marking for the timing chain on 1997 Mercedez C280?
Need to know where the timing marking are on a 1997 Mercedez C280? I'm doing a head gasket job.
Fuse location for Mercedes c280 Climate Control?
c280 fuse diagram
You have Mercedez Benz 1998 C280 your air condition do not work you by pass the electical run direct power to the compresor and all work ok how you can find where is the electrical troble?
it shut down on low gas presure or sensor is bad inside car
Location of Oil Dipstick for Mercedes Benz C280?
where is the oil dipstick located on a 1998 mercedes benz c280
What kind of motor oil do you put in a 1998 Mercedez Benz C280?
I always use Motul 20w/40. It is not synthetic, and change it every 7500 km.
How do you replace AC expansion valve on Mercedes c280?
how do I replace the AC expansion valve on a Mercedes C280 sedan. location and procedure
Where is crank position sensor located on 1997 C280?
Where is the crank position senson located on the car
What could be the problem with the radio not getting any power on a 1998 Mercedez Benz C280?
most likely the radio is not grounded properly. 90% of the time this is the answer to your question. ( former sterio installation tek).
How can you fix speed sensor for c280 Mercedes?
Speed sensors generally are not serviceable. The sensor needs to be replaced. It should be an easy change out, either bolted on or screwed in.
Where is camshaft position sensor on Mercedes c280?
The camshaft Hall-effect sensor is located at the front of the engine (standing at front of the car) to the right close to thermostat valve. It is suplied with voltage from de relay module.
Where is the knock sensor located on 96 c280 mercedes?
On a 1996 Mercedes-Benz C280, the knock sensor is typically located on the engine block, near the cylinder bank. Specifically, it can be found on the side of the engine, often near the intake manifold. Accessing it may require removing some components to reach it, so it's advisable to consult a repair manual for detailed instructions.
Where is the ac fuse for Mercedes c280?
Where is the fuse box on my 1999 c280 mb
