The Differential Pressure Feedback EGR (DPFE) sensor on a 1998 Ford E350 is typically located near the EGR valve, often mounted on or near the firewall of the engine compartment. It is connected to the EGR system via two small hoses that measure the pressure difference in the exhaust gas. For precise location, it's helpful to consult the vehicle's service manual or a repair guide.
On a ford e350, the bank two sensor two is on the drivers side. The sensor is the one behind the catalytic converter.
98 Ford E350 The AIT sensor is just after the air filter housing. It has two wire going to it, one is gray and the other is gray with a red strip. The sensor can be remove easily as it is just snug press into the rubber air intake housing.Read more: Where_is_the_IAT_Intake_air_temperature_sensor_on_a_Ford_Econoline_E-350
IT MAY BE LOCATED IN THE TAILSHAFT OF THE TRANS, OR IN THE REAR DIFFERENTIAL HOUSING TOP FRONT DRIVER'S SIDE
in the tank
yes
My 1998 E350 takes 6.4 litres, just changing last night
replace transmission speed sensor for a E350 mercedes benz
electrical
The book on my 1998 Ford E350 says to use 5W-30.
check the intake breather area between the air filter and the intake. there should be a sesor connection comming it. the one on my e350 is located inside the large tube.
14 quarts
how many o2 sensors on a ford e350 van 2003