The G sensor, or accelerometer, in a 1997 Isuzu Trooper is typically located within the vehicle's airbag control module. This module is usually found under the dashboard, near the steering column or behind the center console. For precise access, it's advisable to consult the vehicle's service manual or a repair guide specific to that model.
The G sensor, or gravity sensor, in a 1997 Isuzu Trooper is typically part of the vehicle's anti-lock braking system (ABS) and is used to measure the vehicle's lateral and longitudinal acceleration. It is usually located in the engine compartment, often near the ABS control module or mounted on the vehicle's chassis. If you're troubleshooting issues related to the ABS or stability control, it's important to refer to the vehicle's service manual for the exact location and specifications.
My guess would be wheel balance.
No. The isuzu trooper 3.5 will work with a 98-2005 rodeo but a 97 is a first gen. The 3.5 is the bored stroked version of the 3.2 with all the same connections as the 2nd gen Rodeos. The 1st gen Rodeos used a different 3.2 with different connections.
Where is my filter for my 97 ISUZU RODEO
where is located theknock sensor 97 mitssubishi eclipse
the sensor is in the dist
where is the crank sensor located on my 1997 Chrysler sebring lxi
DID YOU TRY CHANGING OUT THE BATTERIES ON THE REMOTE??
On a 1997 Isuzu Trooper, the O2 light reset switch is typically located under the dashboard, near the driver's side. You may need to remove a cover or panel to access it. The switch can usually be identified as a small button or toggle. Refer to the vehicle's manual for specific instructions and the exact location.
it depends on the model of engine, my 97 rodeo with the 4ze1 motor has the map sensor for air intake but doesnt have an O2 sensor for the exhaust.
where is egr temp sensor located in 97 nissan pickup l4
ihsiqwhdiqwehudhejkdjbdjkgbekd