inside the distributor
where is the IAT sensor located on 99 qx4 infiniti
On a 1998 Infiniti QX4, the camshaft position sensor is typically located near the front of the engine, on the driver's side, near the cylinder head. It may be positioned near the timing cover and can be accessed from the top of the engine. To get to it, you might need to remove some components for easier access, depending on the engine layout. Always refer to the vehicle's service manual for specific details and diagrams.
The oil filter on a 1998 Infiniti QX4 is located on the bottom, right side of the engine. It is positioned in an downward angle to allow for easier removal.
Replace the camshaft sensor for whichever bank the code specified. Simple fix
on the driver side
1200-1500
To replace the camshaft seal on a 1998 Infiniti QX4, first, disconnect the battery and remove any components obstructing access to the camshaft area, such as the valve cover. Next, carefully remove the old seal using a seal puller or a flat tool, ensuring not to damage the surrounding surfaces. Lubricate the new seal with engine oil and gently press it into place, ensuring it sits flush. Finally, reassemble any removed components and reconnect the battery.
In the 1998 Infiniti QX4, the intake air temperature sensor is typically located in the air intake duct, just before the throttle body. It may be mounted directly on the air cleaner assembly or integrated into the mass air flow sensor, depending on the specific setup of the vehicle. This sensor monitors the temperature of the incoming air to help optimize engine performance and fuel efficiency.
Your auto parts dealer can give you this information when you purchase your spark plugs. But a 1998 Infiniti QX4 gap is .041.
Mass Air Flow Sensor.
245/70/16