unshielded twisted pair (utp)
Alien Crosstalk (AXT) As the signal rate increases in a cable, this form of crosstalk becomes more important. In Fact, this is a major source of interference, and a limiting factor, for running 10GBase-T (10Gbps) over UTP cabling.
Any shielded copper cable or fiber optic cable.
Twisted pair cable is a type of wire in which two conductors of a single circut are twisted (paired) together for the purposes of canceling out electromagnetic interferance from outside sources and crosstalk between neighboring pairs of wires. The amount of twists per meter changes along the length of the cable.
Small Population
A 66 MBps or faster PATA (Parallel ATA) drive requires an 80-wire, 40-pin IDE cable. This type of cable supports faster data transfer rates by allowing for better signal integrity and reducing crosstalk between the wires. The 80-wire cable is typically distinguished by its additional ground wires, which are interspersed with the data wires. It's important to ensure that the cable is properly connected to both the drive and the motherboard for optimal performance.
Backbone cabling
A type of cable that consists of two independently insulated wires twisted around one another. The use of two wires twisted together helps to reduce crosstalk and electromagnetic induction. While twisted-pair cable is used by older telephone networks and is the least expensive type of local-area network (LAN) cable, most networks contain some twisted-pair cabling at some point along the network. Other types of cables used for LANs include coaxial cables and fiber opticcables.
small populations
small populations
SATA IDE cable do most hard drives use toda.
It depends on the type of LAN; the most common cable in a LAN is UTP cable. In older LAN types you could also use coaxial copper cable. For UTP cable that would be Cat 5, cat 5E or above for most LANs.
Twist pair cable