0
Which command can be used at the command line to start the Network Configuration program?
To start the Network Configuration program from the command line, you can use the command nmtui for a text-based interface or nm-connection-editor for a graphical interface, depending on your system configuration. Alternatively, on some systems, you might use network-manager or nmcli for command-line management of network connections. Make sure to run these commands with appropriate permissions if required.
What else can I help you with?
Which command can be used at the command line to start the printer configuration program?
Ubuntu: system-config-printer brings up a GUI printer configuration
What command prompt do you type for system start configuration?
F9
How do you start the display program in Linux from the command line?
the command "display" brings up the ImageMagick program.
What DOS command will start text editor program?
Run "edit" command..
How do you test network connectivity and Network Interface card functionality?
Testing the network card itself involves running a diagnostic program that is usually supplied by the vendor that manufactored the card. For basic network connectivity you can start with the 'ping' command move up from there depending on what is found.
What are the fuctions of the network command?
it start the routing protocol on interfaces. it allows the router to advertise a network.
What command is used to execute an Apache program?
apachectl start
What command is used to delete the configuration stored in NVRAM?
erase startup-config
What is the command for saving the router's running-configuration to non-volatile memory is?
copy run start
What is the purpose of using Netstart command utility?
To start the specified network service.
How do you execute an Apache program in Linux?
Enter this command as root: "apachectl start"
The command used to execute a BASIC programme?
Assuming a BASIC program is loaded into memory, the correct command to execute a BASIC program is: RUN. If you would like to start your program at a particular point in the execution, you may use RUN [#], where [#] is the line number you would like to start execution at.
