answersLogoWhite

0

What else can I help you with?

Related Questions

What pieces of information are contained in a routing table entry?

The metric value of the route The address of the logical destination network The type of learning method involved


Which two commands can be used to modify the default OSPF metric calculation of a link?

The "ip ospf cost" command can be used to manually set the cost of an OSPF-enabled interface. The "bandwidth" command can indirectly affect OSPF metric calculation by adjusting the bandwidth on an interface, which in turn affects the OSPF metric calculation.


How do you change km to mph in the speedometer in a 1991 Lincoln Town Car?

If you have the trip computer there should be a button that changes the displays from metric to standard and back.


When is a metric on a set complete?

A metric on a set is complete if every Cauchy sequence in the corresponding metric space they form converges to a point of the set in question. The metric space itself is called a complete metric space. See related links for more information.


Is ounce a metric measure?

There are "metric ounces", but there are other types, as well. Refer to the Wikipedia link, below, for further information.


How many milaliters are in a bottle liter of water?

As defined by the metric prefix milli, meaning 10^-3, 1000 mL of water are contained in a L bottle of water. For that matter, 1000 ml of anything are contained in a L bottle of anything.


How could a network technician configure a static route that does not require a recursive lookup?

On a PC this is achieved using a manual entry to the routing table using the command ROUTE ADD using the example provided from the command shell: route ADD 157.0.0.0 MASK 255.0.0.0 157.55.80.1 METRIC 3 IF 2 destination^ ^mask ^gateway metric^ ^ Interface^


How many milliliters is 30 milligrams of Methadone?

This cannot be solved without more information. Milliliters is a metric capacity measurement. Milligrams is a metric weight measurement.


What is the Comparence metric system and standard system?

There seems to be a misunderstanding, as there is no widely recognized metric system called the "Comprence" metric system. The standard metric system is the International System of Units (SI), which is based on seven base units such as meters, kilograms, and seconds. Can you provide more information about the "Comprence" metric system for further clarification?


How would i measure the area of my gym floor using the metric system?

Depending on your location, it might be difficult to come up with a meter stick or a tape measure that displays centimeters and meters. It's probably better to measure it in feet and inches and convert it to metric mathematically.


What thermometer is based on the metric system?

That depends on what units the thermometer is calibrated in. The SI unit for temperature is the kelvin, but degrees Celsius commonly used, if the thermometer reads in kelvin or degrees Celsius then it is a metric tool.


BIO-METRIC IDENTIFICATION SYSTEM FOR ACCESS INFORMATION IS STORED ON?

any military id card