0
What else can I help you with?
What is the command to determine if interface Ethernet 0 is active?
Run "ipconfig".. If your Ethernet will be active it will show you the current IP address of NIC..
How do you test a Ethernet port?
to check if your Ethernet card r INTERNET is working r not, just type the following in command prompt: ping 127.0.0.1 This command is basically used for self test of NIC(Network Interface card) card
What are four additional pieces of information that the ipconfig command with the all switch provides that the ipconfig command alone does not?
Four additional pieces of information that the IP config command with the all switch provides that the IP Config command alone does not include are: Windows IP Configuration Ethernet adapter Cluster Ethernet adapter Administration Connection-specific DNS Suffix
What impact does the use of the mdix auto configuration command have on an Ethernet interface on a switch?
automatically detects copper cable type
How do you tell what Ethernet card is installed?
To identify the installed Ethernet card on your system, you can use various methods depending on your operating system. On Windows, open the Device Manager, expand the "Network adapters" section, and look for the Ethernet card listed there. On Linux, you can use the command lspci | grep -i ethernet in the terminal to display details about the Ethernet hardware. Additionally, you can check system information tools or network settings for more details.
Where can one find more information about Ethernet serials?
To find the ethernet serials in Windows 8, you begin by opening the command prompt window. To do this you right click anywhere on the startscreen and select "all apps". Move to the right, and find the "Windows System" area. Click on "Command prompt". When the window is opened, you enter "vol". You then receive the Disk Serial Number. On older Windows Versions, you do the same, but the command prompt is entered through Start menu -> All Programs -> Accessories --> Command Prompt.
Which command output would you most likely see if you had a problem at the physical layer?
Ethernet 0/0 is down, line protocol is down
What is the purpose of the network command in configuring RIP?
to identify the directly connected networks that will be announced in RIP updates
In nascar sponcers like army and National Guard is that tax payers money?
Yes, but it is funds budgeted for advertisement as part of Recruiting Command.
How would a technician permanently change the IP address of an Ethernet card on a Red Hat Linux PC?
Command to change the IP address on Linux is ifconfig.Run ifconfig to find the interface name for the connected Ethernet card. If there is only on ethernet card present on your system then the interface name would be eth0. If there are more than one Ethernet cards present on your machine then they interface names will be ethn.Once you have figurred out the interface name then ifconfig command can be used to modify the IP address$ ifconfig eth0 upeg$ ifconfig eth0 192.168.1.100 upWould assign new IP address to eth0
An administrator enters the show ip route command into a router What type of information will be displayed?
the networks learned from other neighbors
Which network compliments ISAF fixed voice and data communications networks in the Kabul area?
ISAF Command Radio NET.
