Either...
(a) you're router isn't working
(b) you're out of range of your router or
(c) your computer's wireless component isn't working.
The power supply's power-good signal prevents a computer from operating on improper voltages and potentially getting damaged. Typically, a computer will only start up after receiving the power-good signal.
You will need the start up disk that comes with Windows program. It will be the disk with a code on the back of the packaging. Place the disc in the drive and then re-boot your device.
This message means someone tried to start the computer with the case open, AND that the BIOS is set to halt if the chassis intrustion switch indicates that the case is open.
how to shut down computer correctly??
Start error means that the "chipped" key message is not getting to the proper computers. You need a scan tool to check codes in the engine, skim, cluster, etc.
* Uses a signal wire to start and shut down the computer * Contains transformers and capacitors
Sometimes I start my computer in the morning and I'm not getting my wireless Actiontec signal on my computer. After trying different things I got it back to working. I had my computer on. I unplugged the Actiontec. I took the green phone line out of the wall plug. I plugged the Actiontec back in again. I plugged the phone line in the wall again. It started working again!
When they start getting dementia.
check the fuse, check the relay, change the ignition module-- it senses the engine turning over and sends the computer the signal to start the pump. Check the collision sensor in the rear, it may need to be reset.
# Go to start on your computer # go to run # find msconfig # delete everything on it # Next time you start your computer it will show you a message # select don't show message again. This will turn of all kinds of programs that you don't need to have running and any thing you do need the computer will reinstall at startup.
Apparently you can't.
start by getting a web cam. after get an account on youtube then you can proceed