Use "/?" option with command. For example, if you want help for "chkdsk" command, enter "chkdsk /?" and press enter.
First you enter the password. Then, you click the enter key. When it says command, type in the correct command and press enter again.
There is no such command. Obviously, in order to enter a command into the prompt, Linux must already be on.
You have to enter the password and the launch command to launch the Giant Rabbot. The password is from the Printing Room : fuzzybunny (enter) The launch command is on the sticky note : launch rabbot (enter)
You can enter a command by using the keyboard. Some commands also have abbreviated names called command aliases.To enter a command by using the keyboard, type the full command name on the command line and press ENTER or SPACEBAR.Specify Command OptionsWhen you enter commands on the command line, you see either a set of options or a dialog box. For example, when you enter circle at the command prompt, the following prompt is displayed:Specify center point for circle or [3P/2P/Ttr (tan, tan, radius)]:You can specify the center point either by entering X,Ycoordinate values or by using the pointing device to click a point on the screen.To choose a different option, enter the letters capitalized in one of the options in the brackets. You can enter uppercase or lowercase letters. For example, to choose the three-point option (3P), enter 3p.Execute CommandsTo execute commands, press SPACEBAR or ENTER, or right-click your pointing device after entering command names or responses to prompts. The instructions in Help assume this step and do not specifically instruct you to press ENTER after each entry.Repeat and Cancel CommandsIf you want to repeat a command that you have just used, press ENTER or SPACEBAR, or right-click your pointing device at the command prompt.You also can repeat a command by entering multiple, a space, and the command name, as shown in the following example:Command: multiple circleTo cancel a command in progress, press ESC.
To clear the Command Prompt window, enter CLS
Config ?
To launch the command prompt in run, type CMD and hit enter/ok.
Go to the command prompt and run "ver" command..
It should say enter your 6 digit code which is 606751. Then you connect to technician. There should not be a fee.
Start -> Run type CMD and hit enter. a black DOS Command prompt will appear. type IPCONFIG and hit enter.
When you are in the carrot factory and you have talked to the guy in a pink bunny suit (Dr.Rabbot) You go to the command station to launch the bunny there is a little post-it note on the corner of the screen that says "launch rabbot" this is the command