answersLogoWhite

0

Scroll down to related links and look at "Interconnection of two units" and find the picture of the amplifier and the loudspeaker. Learn about "voltage bridging" - Zout < Zin.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Sony Str De 597 Connect the receiver to the subwoofer speaker?

At the rear of the receiver there is a single RCA jack (phono socket) that is marked "audio out" and "sub-woofer". This is a mono feed that can be connected to a powered sub bass unit. It will not drive an un-powered bass speaker that does not have an internal amplifier. If the bass speaker is not powered, the audio out from the receiver can be taken to a single channel of another amplifier and the bass speaker then connected to the speaker output of the amplifier.


Will your 500w amplifier blow your 250w speaers?

Possibly, if you turn the volume up, but not necessarily. You should attempt to match impedance (your amplifier is designed to have specific speaker impedances connected, if these are not connected it will not deliver full power).


Is every resistance load resistance?

No. Load resistance is the value of the element actually doing the work of the circuit it is connected to. A speaker connected to an amplifier is the load.


What can you put inside the sound hole to make the guitar sound louder?

A microphone connected to an amplifier and speaker(s).


How do you install subwoofers with no amplifier?

What I have done before is i attached wires from my door speaker and connected my sub. It sounded pretty good.


How can I connect an acoustic guitar to a speaker?

To connect an acoustic guitar to a speaker, you can use a guitar cable to plug the guitar into an amplifier or a PA system. The amplifier or PA system can then be connected to the speaker using another cable. Make sure to adjust the volume levels carefully to avoid distortion or feedback.


Do you need an amp to play a theremin?

An amplifier and speaker is recommended for most theremins, however, some theremins may provide enough audio output power to directly drive headphones or a speaker. Some commercial theremins have an internal speaker.


How can I safely connect a 16 ohm speaker to an 8 ohm amplifier without causing any damage to the equipment?

To safely connect a 16 ohm speaker to an 8 ohm amplifier without causing damage, you can use a series resistor in line with the speaker to match the impedance. This resistor should have a value of 8 ohms to create a total impedance of 16 ohms when connected in series with the 16 ohm speaker. This will ensure that the speaker and amplifier are properly matched and protected from damage.


How does the first computer speakers look like?

The first computer speaker was an ordinary speaker with vacuum tube amplifier connected to the MSB of the accumulator, it was used to assist in debugging. It looked no different than an ordinary audio speaker of the time.


How can I safely connect an 8 ohm amplifier head to a 16 ohm speaker cabinet?

To safely connect an 8 ohm amplifier head to a 16 ohm speaker cabinet, you can use a series connection method. Connect the positive terminal of the amplifier to the positive terminal of the speaker, and then connect the negative terminal of the speaker to the negative terminal of the amplifier. This will create a total impedance of 24 ohms, which is safe for both the amplifier and the speaker.


What gauge speaker wire for car amplifier install?

Depends on the output of the amplifier.


What are the potential consequences of connecting a 16 ohm speaker to an 8 ohm amplifier?

Connecting a 16 ohm speaker to an 8 ohm amplifier can potentially cause damage to the amplifier due to mismatched impedance. This can result in overheating, distortion, and ultimately lead to the amplifier failing. It is important to match the impedance of the speaker and amplifier to avoid these consequences.