Battery cables are not supposed to be hot. Cables may become hot if there is too large of an amp draw, meaning there is a problem that needs attention. yes
yes
Weak battery, weak starter, resistance in the battery cables, ignition timing,
It could but, have the battery tested before you purchase a new starter.
Adaptec offers SAS and SATA RAID Adapters, Hot Bus Adapters, cables and accessories such as: SAS HD cables, Serial Attached SCSI cables, flash and battery modules.
You can purchase battery cables online for a low price. A good place to find these is at discount marine supplies. They carry battery cables and are discounted, too.
I have a 1995 Ford Explorer , and with the engine running a mechanic disconnected both battery cables and it kept running - I was surprised!
I would replace the starter and both battery cables.
Disconnect the Regal battery cables. Find the battery clamp then remove it. Lift the battery out, then put the new one in. install the clamp, then connect the battery cables.
disconnect the battery cables. find the battery clamp and remove it. Lift the battery out, then set then new one in place. Install the clamp, then connect the battery cables.
When using battery cables to start a car, once it has started is there a procedure when removing the cables from the running car?
THe battery is under the back seat so you have to TAke all theose cables out
Take both cables off. Remove old battery. Put new battery in. Put cables back on.
Just connect the battery to the motorcycle battery cables with jumper cables and then start it.