You can - but it will take a little longer to charge the higher capacity battery.
Put a battery charger on it.
h
Use a battery charger with a 2amp charge. Takes a few days. These small batteries don't like to be charged too fast with high amps.
How many amps vtx 1300 battery
YTX14-bs
12 volt
under the seat.
The average Canon 18 200 will cost you anywhere from $700-1300 depending on where you purchase it and what accessories it has included. Lenses are extra.
If you have a manual charger follow the charging instructions. After a full charge, do an On-Charge Voltage Test. Get your volt meter out and set it to 200v dc with the charger on. We will be checking individual battery voltages, start with the #1 battery (where the positive lead goes to the cart) placing the positive lead of the voltmeter on battery positive and the negative lead of the voltmeter on battery negative, move down the line until the last battery. For 36v carts with six 6v batteries we want each battery to read at least 7.0v. For 48v carts with six 8v batteries were looking for at least 9.3v on each battery. Put your safety glasses and safety gloves on. Remove all battery caps. Get your hydrometer out and start with the #1 battery take your sample from each battery cell and write it down. You should have readings of 1100 to 1300, 1100 being close to water and 1300 being acid. Start with the #1 battery. If there is a difference of 50 points or more between cells you have a bad battery. Here is an example of a good battery. 1265 1275 1265 Here is an example of a bad battery: 1265 1175 1265
Most match grade .22 runs at about 1050 fps. Various bullet weights and powder charges will produce different velocities, but figure from about 1000-1300 fps.
you will have to install a plug onto the battery terminals
To remove the battery from a Yamaha Royal Star 1300, first, ensure the motorcycle is turned off and parked on a stable surface. Locate the battery compartment, typically under the seat or side panel. Remove the seat or panel by unscrewing any fasteners, then disconnect the negative (-) terminal first followed by the positive (+) terminal. Finally, lift the battery out of its compartment carefully.