Some of them do. Your CD-ROM and hard drive can have molex power connector, or/and SATA power connecter. I think SCSI interface uses molex power connectors too.
Each IDE connector on the board supports two channels per. (Two drives) The combination of drives can vary. For instance, hard drive-cdrom, hard drive-hard drive, cdrom-cdrom, ect....ect.
your power supply has a small plug attach to it with several larger ones that go to your cdrom and hard drive it will fit in to the back of your floppy
It connects the drive to the system power supply.
yes adjust the jumper at the back of the drive. it's a white block. it between the interface connector and power connector. you also want to set it aswell in the bios.
A technician is installing a new power supply in a computer Which type of power connector should be used to connect to a PATA hard drive?berg mini-molexmolex.20-pin ATX connector
hard drive.
MOLEX connectors provide power for IDE hdd & CD-ROM drives
The hard drive should be on the bottom connector and all you other drives on the top connectors. Thats how mines connected!!!!!!!! :-)
Where to buy Motorola ml900 hard drive
There's different types of connections that lead to a hard disk. you'll have to ellaborate your question.But..... I can tell you what the wires are....There's the ribbon cable. (flat and wide cable that connects to the back of your drive to the motherboard)The Molex plug (white and it has four pins) that powers your hard disks, it leads to the power supply.OR... The SATA power connector (which is black, has 5 wires (red, yellow, 2 black, and one orange) which connect to the back of your hard diskThere's also the SATA data transfer cable, it's a thin (usually red) cable that connects to the motherboard to your hard drive. (it's a thin "L" shaped slot)
An IDE connector is used to connect a CD-ROM drive or hard drive to a motherboard, with a long and flat ribbon cable.
The SATA connector cable, or whatever connector cable you have from the drive to the motherboard.