Hold the button you want to program and then hold the on/off button at the same time it should program
how do I program the Dale Earnhardt remote control
InstructionsAutomatic Code Search1 Turn on the first device you want to program to the Gemstar remote control.2 Hold down the button you want to program, for example "DVD," while holding the "ON/OFF" button until the red indicator light comes on. The remote control is now in programming mode.3 Point the Gemstar remote control at the device and press the "Play" button. The indicator light will blink for approximately five seconds as it searches the first group of codes.4 Press the "Play" button after the indicator light stops blinking to check the first group of codes. Continue doing this until the device powers down.5 Push the "Reverse" button and wait approximately 2 seconds. Continue doing this until the device turns on again.6 Save the code setting by pressing and holding the "Stop" button until the indicator light stops blinking.7 Repeat Steps 1 to 6 for each device you want to program to the Gemstar remote control.Direct Code Input8 Review the last page of the RCA Gemstar remote control user manual. This page has a list of device manufacturers. Look up your device's manufacturer to find the remote codes for your device.9 Turn on the device you want to program to the remote control.10 Press and hold the button you want to program, such as "SAT/CABLE," and use the keypad on the remote control to enter the first code from the list.11 Release the button you want to program and press the "ON/OFF" button to see if the programmed code worked. The device should shut off if the code was successful.12 Repeat Steps 3 and 4 with the next code on the list until you find a code that operates the device.13 Program the rest of the devices you want controlled by the Gemstar universal remote control by repeating Steps 1 to 5.
how to program my tv with the RCA D 770 - universal remote control which has no code search button
What is the Universal Remote Code for a Samsung LN32D450G1DXZA
rca universal control
In the instructions it should say how to program it to your own garage door. Much like a universal remote control for your television.
To program codes in a GPT universal remote control, RM-788, first you need to know the make and model of your television set. Then you find that code number on the pamphlet that came with the remote and enter it on the remote.
0000
To program a GPT universal remote control, hold down the power button at the same time with the button for the device that is going to be programmed. When the other buttons on the remote blink, let up and press on the power button again. The device should turn on. If not, repeat the process.
how to program
You need to use the pamphlet that came along with the remote control. You need to put in the code number for your TV.
The system and device is OK now. Imalent EU06 3 in 1 touch screen LED flashlight with remote control.