Press the channel number you want to program, then press, pr, now inter the frequency. then press channel number again. Good luck Bill Rusher warusher@ftc-i.net
To program the Regency Model ACT-T16K, you typically need to access its programming mode by pressing the designated buttons (often a combination of the "Mode" and "Channel" buttons) while powering on the device. Once in programming mode, you can set frequencies, privacy codes, and other parameters using the keypad. After making your adjustments, ensure to save the settings before exiting programming mode. For detailed instructions, always refer to the user manual specific to the ACT-T16K model.
How do you program regency d300. the model number d300.
Programming scanner r1040
EBay is about the only place these days
use the state button it has about 50 channels for each state
To program a Regency MX-3000 scanner, start by turning on the device and accessing the menu. Use the keypad to navigate to the programming section where you can input frequencies manually or enter specific channels. You can also use the software provided by Regency, if available, to make programming easier via a computer connection. Finally, save your settings and ensure the scanner is set to the desired mode for receiving transmissions.
During the Regency
The act of congress that established the JROTC Program is the National Defense Act of 1916.
The population of Dompu Regency is 218,984.
Subang Regency's population is 1,465,157.
Blitar Regency's population is 1,116,010.
Blitar Regency was created in 1324.