When you set up a Uniden Bearcat BC148XLT base scanner, you must program the frequencies you want to scan based on your area's frequencies. You do not need to include weather frequencies, because the BC148XLT includes weather frequencies pre-programmed in the base. You can add frequencies to your scanner in minutes, allowing you to customize the frequencies you scan.
Press "Manual" to stop the scanning process. Press the number for the channel you want to program using the keypad on the scanner base. Press "Manual" after the channel number.
Enter the frequency, including the decimals, using the buttons on the keypad.
Press "E" to store the frequency.
a program is called a program. a set of instructions is called a manual.
easy to program
To program a frequency of 139.21000 MHz into a BC 142XL scanner, first turn on the scanner and press the "MANUAL" button to enter manual mode. Then, use the keypad to enter the frequency as "139210" (the MHz and kHz are implied). After inputting the frequency, press the "E" or "ENTER" button to save it. Finally, you can press the "SCAN" button to start scanning or "MANUAL" again to listen to the programmed frequency.
For a comprehensive database of active frequencies in your area, and a lot of other useful scanning info, take a look at the link below.
Try programing in 000.000, if that does not work then you can just lock the frequency out or program over it.
BC 560XLT 16-Channel Direct Entry Programmable ScannerPROGRAMMING CHANNELS1. Turn on your scanner by turning the volume clockwise.2. The scanner might strart scanning. If so, press MANUAL to stop thescanning.3. Enter the channel number that you want to program and press MANUAL.4. Enter a frequency including the decimal point. The decimal point showsup on the display as a -- (dash).5. Press Enter to store the frequency.6. To confirm the proper entry, press REVIEW. The programmed frequencyappears on the display one digit at a time.7. To program more channels repeat steps 3-4.
I had this virus and Panda online scanner removed it! pandasoftware.com
To delete a frequency on a Bearcat BC 147XLT scanner, first, ensure the scanner is in the correct mode (e.g., frequency or channel mode). Navigate to the frequency you wish to delete using the UP/DOWN buttons. Once on the desired frequency, press and hold the "DELETE" button until you hear a confirmation beep. The frequency will be removed from the memory.
Free trainsit ticket
Use "bc". For example:- [irb@eddie ~]$ echo "1 + 2 + 3 + 4" | bc 10 [irb@eddie ~]$ Use "man bc" to learn more about this calculator program.
There is no such thing as 'the greatest number'. Here is a program in unix to prove it: echo 'for (i=1; i>=0; i= i*2) print i,"\n";' | bc if you want to actually see the output use it this way: echo 'for (i=1; i>=0; i= i*2) print i,"\n";' | bc | less -S
BC' + BC' = 2BC'