How do you program dish 20.0 ir?

Answer 1

You didn't specify what you wanted to program the 20.0 remote to so I have provided instructions for addressing the remote to your receiver and programming the remote to your TV.

Address Remote to TV/Other Devices

1. While at the device location (TV, etc), point the remote at the device. Press and hold the device button on the remote (TV, Aux, etc). - All four mode buttons should light up
2. Enter the three-digit remote control code - The mode button (TV, Aux, etc.)you selected should light up

1. Press the Pound (#) button - The mode button you are programming should flash three times
2. Press the large, red POWER button - The device should turn off

Readdress to receiver:

1. Press the SYSTEM INFO button on the front panel of your receiver. Avoid accessing the "System Info" screen using the remote control, as this could cause re-addressing both impacted remotes. - Note the remote address shown in the UHF remote address box

2. Press and hold the SAT mode button on your remote until all of the mode buttons light up - All four mode buttons should light up

3. Use the number pad on your remote to enter a remote address between 1 and 16, not including the address you originally noted in Step 1 - The SAT button should light up

4. Press the POUND (#) button - The SAT button should flash 3 times

5. Press the RECORD button - If the steps are successful, the number entered in Step 4 should display on the "System Info" screen

6. Select "Done" to close the "System Info" screen