answersLogoWhite

0

Mine is under the rear seat just unbolt it and remove the cables

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where do you disconnect the battery in a 1998 olds aurora?

The battery in 95-98 Aurora are located under the back seat cushion. To access you must lift the cushion by pushing in on the bottom rim from inside towards the trunk and lift up at the same time. To remove battery cables you need a 5/16 socket, and to remove the battery retainer use a 1/2 socket.


How do you unlock the car when the battery is dead in an 1998 Oldsmobile aurora?

I would use my key


Where is the battery on a 1998 Oldsmobile aurora?

under the back seat! Under the back seat


Can you put a regular battery in 1998 aurora?

Yes, as long as it is the correct size battery with the correct cold cranking amps.


How do you install battery on 2001 Oldsmobile aurora?

pull front of rear seat up. remove it and battery is right there


1998 aurora will not hold a battery charge?

Then either something is on draining the battery or the battery has a dead cell draining all the rest and must be replaced.


How do you remove a battery for a 1998 BMW 528i?

how o you remove a battery for1998 bmw 528i?


Where is the starter in a 1998 Oldsmobile aurora?

under the intake manifold you have to remove the engine cover to get to it.


What would cause a 1998 aurora to turn over but not start?

battery is good , c- pack's good will not start


How to change battery on 1998 buick regal?

To change battery on a 1998 Buick Regal, first remove the windshield washer fluid reservoir. Then remove the massive air flow housing to be able to remove the old battery and replace with a new one.


What is involved in taking off headlight assembly on a 1998 Aurora?

To remove the headlight assembly on a 1998 Oldsmobile Aurora, you’ll need to start by disconnecting the battery to ensure safety. Next, remove the screws or bolts that secure the headlight assembly, which are typically located at the top and possibly on the side of the assembly. After removing the fasteners, gently pull the assembly forward to disconnect the wiring harness and remove it completely from the vehicle. Finally, replace or service as needed before reinstalling the assembly in reverse order.


How do you replace blend door 98 Oldsmobile aurora?

To replace the blend door in a 1998 Oldsmobile Aurora, first disconnect the battery and remove the dashboard trim to access the HVAC controls. Then, take out the heating and air conditioning unit to reach the blend door assembly. Remove the old blend door and install the new one, ensuring it is properly aligned. Reassemble the HVAC unit, reconnect the battery, and test the system to ensure it operates correctly.