answersLogoWhite

0

To reset the belt on a Kenmore canister vacuum cleaner, first, unplug the vacuum for safety. Remove the bottom plate or brush assembly by unscrewing any screws or releasing latches. Check the belt for proper alignment or damage, and if necessary, replace it before reassembling the vacuum. Finally, plug the vacuum back in, and it should function correctly with the reset belt.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Where to Find reset button on eureka vacuum?

The reset button on a Eureka vacuum is typically located on the back of the vacuum cleaner near the motor. It may be a small red or black button that you can press to reset the vacuum cleaner if it has shut off unexpectedly. Refer to the manual for your specific model for the exact location of the reset button.


Does a Kenmore stove have a reset button?

No


If i factory reset my laptop computer will I lose my antivirus and CC cleaner?

If you do a factory reset then yes you will loose everything.


How do you reset a circuit breaker on a shop vac?

To reset a circuit breaker on a shop vac, first unplug the machine. Locate the circuit breaker on the power cord or the vacuum itself and press the reset button. If the breaker doesn't reset, check for any obstructions or issues with the vacuum that may be causing the problem.


Code p1443 and changed the canister purge valve but check engine light still on?

you need to unhook your negative cable for a few that will reset>


How do you reset the ac compressor for charging Aveo?

If the system is being completely filled, a vacuum will have to be pulled on the system. If the system just needs to be topped off then a vacuum pull is not needed.


What does f-01 mean on Kenmore dryer?

The f-01 error code on a Kenmore dryer typically indicates a problem with the control board or a communication issue between the control board and the motor control unit. This may require a reset of the dryer or, in some cases, replacement of the control board. If the error persists after a reset, it's advisable to consult the user manual or contact a professional technician for further diagnosis and repair.


How can you reset your o2 sensors on your 2001 Ford 4x4?

You can not reset your oxygen sensors. You can only replace them. To reset the check engine light you will have to get that done by a repair shop with a computor. If replacing the sensors does not repair the problem then check for a vacuum leak.


How do you reset the ABS Light in a 1995 Acura Legend?

YOU CAN TAKE IT TO A SHOP AND HAVE THEM PUT IT ON THE SNAP ON COMPUTER AND RESET IT...HOWEVER..IF YOUR SENSORS ARE DIRTY IT WILL CAUSE IT TO COME BACK ON I WOULD TAKE THE WHEELS OFF...FIND THE SENSORS REMOVE THEM AND THEN CLEAN THEM WITH CONTACT CLEANER OR BRAKE CLEANER THEN RE INSTALL THEM..YOU MIGHT CAN REMOVE THE POSITIVE BATTERY CABLE FOR AT LEAST 5 MINUTES AND RESET THE ECM...HOPE I HAVE HELPED ......P.RICH


How do you reset 91 olds ninety eight computer?

brake vacuum line location on the 1991 oldsmobile regency 98


What is a to evap cnstr?

Evaporation Canister. Part of the Evaporation system. If you're having troubles with a pesky check engine light, try replacing the gas tank cap and have the light reset.


How do you reset check engine light on a 1998 ford mustang 3.8L?

somethings wrong still if you light is on most likely has to to do with the EGR valve or a Vacuum leak