Red, positive + cable to Positive + battery terminal. Black, negative - cable to Negative - battery terminal.
You must drill on.
The wire harness for the stereo is suitable for the stereo power. The "ignition" (ACC) wire that is convenient to use for the stereo/accessories is the power wire for the fan control knob. The fan control only gets power in "accessories" or "on" therefore is as good as a remote. __==__-- -- -- ---- -- -- -----^ (Power pin, looking at the front of the fan control plug) (To be sure you are using the right wire (before cutting it), insert accessory wire into the front of plug and see if the stereo works with the key in the ACC position.)
why would my starter wire burn, going from starter to battery
Pull the radio out and cut the little red wire going into the radio.Make sure battery is disconnected when you reconnect battery car will start.
Its a power source such as a battery - Wire from the Positive on the battery to one contact on the lamp and a wire from the Negative of the battery to the other contact on the bulb
The wire that goes to the starter button can be connected to the power wire coming from the battery. Just tough the wire quickly. If the solenoid engages the starter, then it is ok. If not, then there is either no power from the battery of the solenoid is bad.
take off the power wire from the battery.
Battery connectors are what connect batteries to devices so the device can get power from the battery. Electricity is the flow of electrons, and a battery has to have a way for the electrons to leave (negative wire) and return (positive wire). Thus the terminals on the battery are what do this, and battery connectors in a device or vehicle are what carries the electricity to the device or vehicle so it can be used. For instance, they electrically connect the battery to a laptop to power the computer.
Straight to the battery through your firewall straight to the battery to the to the positive post
I think you answered that question yourself, when you said, `hot wire', which usually means the positive battery power lead.
to jump start a Benz, with difficulties getting to the battery, first open the hood of the vehicle and locate the fuse box with the main red power wire, which is screwed in to supply the fuses with power. after locating the wire, hook up your power source such as another without it running and connecting the positive to the battery on one end and the screw head holding the red wire in place. this should provide enough power to allow you to gain access to your battery in the trunk...
Connect one wire from the LED to each of the terminals on a battery - provided the battery has enough power, the LED will glow !