0
Phillips, or Phillips head, refers to the shape of the screwdriver's tip. It forms an X or a cross at the tip, instead of being straight as in a flat head.
Phillips head screws and screwdrivers are less likely to slip while being turned, but it's more important to use the right size to avoid damaging the screw head.
What else can I help you with?
Where do you use a Philips screw driver?
You use a Phillips screw driver on a Philips screw.
Where was the first Phillips screw driver invented?
tallahassi florida
What is the name of a kind of driver used of a four slotted screw?
Philips Phillips
When was Henry F. Phillips born?
in chicago state where he had made the screw driver
How do you replace the front signal lights on a 2000 Toyota Tacoma?
a Phillips head screw driver
What tool is needed to change water temperature in scald-guard shower?
Use a Phillips screw driver.
What are the kinds Screw driver?
Phillips head (the star lookin one) and Flat head (the flat one) :)
What hardware should be used to install the Amish Mission Porch Swing to be sure it will support people sitting on it?
You will need a flat head screw driver, a regular phillips head screw driver, and a hammer.
Who was the inventor of the Philips screwdriver?
The Phillips screwdriver was created by Henry F. Phillips (1890-1958) who was a U.S. businessman from Portland, Oregon . The Phillips-head ("crosshead") screw and screwdriver were both named after him .
What is the best way to choose the right driver bit for a specific type of screw or fastener?
The best way to choose the right driver bit for a specific screw or fastener is to match the bit type to the screw head type. For example, use a Phillips bit for Phillips screws and a flathead bit for flathead screws. It's important to ensure the bit size matches the screw size to prevent stripping or damaging the screw head.
What screwdriver bits do you use on Montana light bulb?
The correct bits are called torques bits. Perhaps a 1.5 torques bit would be used to get to the tail light assembly. However, a regular Phillips screw would call for a #2 Phillips screw-driver.
Where is the radiator drain plug for 200 Nissan altima located?
On the bottom of the radiator, driver's side. It's a plastic phillips-head screw.
