All small appliance branch circuits, typically kitchen, are required to be 12awg. Cu., or 20 amp.
NEC 220.52(A) & (B) state that an additional load of not less than 1500 volt-amperes shall be included for each two-wire small appliance circuit and each laundry circuit.
Typically, a kitchen requires two 20 amp small appliance circuits. These circuits are designated for powering countertop electrical outlets in the kitchen and help prevent overloading when multiple appliances are used simultaneously.
The article designations may change with the code cycle year. In the 2005 NEC see table 310-16 (allowable ampacities for conductors), also article 240.4(D) (protection of small conductors), also table 210.24 (summary of branch circuit requirements for muti-outlet branch circuits)
You can substitute for R-12 in small appliance would be cool water. This is what keeps the inside cold.
The circuits are simply called microchips,because these circuits are too small to be seen clearly with a naked eye.
trancestor
There are lots of great, reliable small appliance repair shops in the D.C. area. I suggest American Appliance Repair, which you can look into at its website: www.washingtonappliancerepair.org
Here are some sentences.A blender is a small appliance.The appliance department is to your left.
well because the particle theory, the conduction makes the conductors have small particles or big so the big ones move faster so they are conductors and the small ones are the insulators
A fuse is a piece of thin wire in a small fireproof container, and current flows through it on the way to the appliance. If there is a fault in the appliance and too much current starts to flow, the fuse-wire melts and stops the current, and it stops any possible fire that the excess current could cause. So a fuse is an important safety device.
No, unless it's a gas range. An electric range requires 240V and 40A while a small appliance will be 120V and Max 15A.
I want to start my own very small appliance repair company. Do I need to be incorporated to do this? Do I need a license?