A slight possibility but not likely
On a 2001 Ford Windstar, the transmission control solenoid is typically located inside the transmission pan. To access it, you'll need to remove the transmission pan, which involves draining the transmission fluid and unbolting the pan. The solenoid is usually mounted on the valve body within the transmission. It's advisable to consult a repair manual for detailed steps and safety precautions when performing this task.
To replace the shift solenoid on a 2001 Tacoma Prerunner, first, disconnect the negative battery terminal to ensure safety. Then, remove the transmission pan by unscrewing the bolts and carefully draining the fluid. Locate the shift solenoid, typically found on the valve body, remove the wiring harness, and unbolt the solenoid for replacement. Finally, reinstall everything in reverse order, refill the transmission fluid, and reconnect the battery.
inside the transmission pan
On the Ford Windstar 2001 model, it is under the hood, next to the battery.
On a 2001 Ford Windstar : The Power Distribution Box is in the engine compartment , between the vehicle battery and the drivers side fender
Battery voltage
my 2001 ford windstar will turn over and make a clanking noise like metal to metal is hitting? Just replaced the starter and had the battery checked what would be the problem?
The torque control solenoid on a 2001 Ford Windstar is typically located inside the transmission, specifically within the valve body. To access it, you'll need to remove the transmission pan and possibly the valve body itself. It's advisable to consult a repair manual for detailed instructions and diagrams to ensure proper identification and handling.
sell it
A 2001 Ford Windstar came from from the factory with the : Motorcraft BXT-65-650 battery or the optional BXT-65-750 battery That's BCI group size 65 , 650 or 750 cold cranking amps
remove battery & case and you will see solenoid attached with three 10 mm bolt head & one elect attachment
Normally goes to the starter or starter solenoid.