answersLogoWhite

0

Place the plate in the freezer for an hour or two. When the wax is thoroughly chilled and brittle, it should scrape off easily.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the throttle plate located on a 1997 ford contour?

The throttle plate is inside the throttle body on the intake manifold. The throttle cable from the accelerator peddle is connected to the throttle plate shaft on the throttle body. If you remove the air cleaner hose at the throttle body, you will see the disc shaped plate.


How do you change spark plugs on a 1997 Mercedes C200?

Disconnect the battery, remove the air hose to the throttle body, remove the access plate, remove the spark plug cables and the boots, and remove the spark plugs. Replace the spark plugs, replace the boots and cables, replace the access plate, attach the air hose to the throttle body and connect the battery.


Transmission sensor for 1999 e320?

Well kind of unclear question but most all sensors for this transmission are attached to the elecro-hydrolic plate which is mounted on the valve body . usually when this transmission has a fault the elecro - hyrdolic plate is to blame. you need to remove trans pan , remove valve body , replace hydrolic plate. correct fluid level.


How to remove labels from glass bottles?

Watch my video on youtube. My channel name: Well Body Well Home


How do you replace the glass headlight cover on a 2000 Toyota Land Cruiser?

it is easier to replace the whole headlight unit (as the glass is sealed to the body), but, if you have just the glass... remove the grill (3 screws), remove the headlight unit (one pop-up, 3 small bolts), place headlight unit on workbench, remove 3 retainer clips, cut sealant around glass, remove glass, apply new sealant to cleaned surface, press glass in place, reverse the above procedure... or just buy the whole thing off ebay ($89)


How do you replace a quarter window 1995 Dodge caravan?

Do you mean the rear vent window?The sliding door,body side and quarter glass vent windows are done using same procedure.1.Remove upper trim moulding from around the glass. 2.Remove the screws holding llatch to glass.3. Separate glass from latch. 4. Remove nut covers and nuts holding glass hinge to window opening flange. 5. Separate glass from vehicle.


What is the plate with the body of Christ called?

The Body of Christ Porcelain Plate?


What are the release dates for Is It a Good Idea to Microwave This - 2007 Is It a Good Idea to Microwave Axe Body Spray 2-25?

Is It a Good Idea to Microwave This - 2007 Is It a Good Idea to Microwave Axe Body Spray 2-25 was released on: USA: 9 December 2007


How long to incinerate a body?

1 microsecond in the microwave.


Why do ants survive in a microwave oven?

Being small keeps the ant close to the conducting metal plate at the base of the oven where the amplitude of the microwaves is minimal. I am not sure whether the ant is able to utilise the interference pattern set up by the microwave sources, but it would if you stopped the plate rotating. In addition the ant has a low fat / water content to minimise energy adsorption and high surface area to body mass ratio which aids heat loss. In addition ants can tolerate high body temperatures (above 50C) and desert species are able to remain active during the daytime.


What would happened if glass was injected?

If glass was injected into the body, it could cause severe tissue damage, internal bleeding, infections, and potentially lead to organ failure. Immediate medical attention would be required to remove the glass and treat any resulting complications.


How do you get body plate on rune scape?

a plate body? you either make it by a smithing skill or you buy it from the Grand Exchange.