answersLogoWhite

0

What else can I help you with?

Related Questions

Is a blender a screw?

yes... because when you turn it on the blades go round and round like a screw. Plus there are things in a blender that are screwed in to hold it together.


does this tip easily?

This blender does not look like it will tip easy since there is a heavy bottom that is located on the bottom of the blender.


How does an electromagnet work in blender?

it connets to the bottom of the machine


What are the release dates for Ro - 2012 The Bottom of the Blender 1-4?

Ro - 2012 The Bottom of the Blender 1-4 was released on: USA: 26 December 2012


Is a coil a simple machine screw?

No because a screw is has a top and a winding bottom and a coil does not have a top and has a winding bottom so no a coil is not a simple machine screw.


Why does a blender have a magnet?

Yes a blender does have an electromagnet in it


How do you change lower unit oil for a 70 hp Johnson?

put engine down. remove bottom fill screw, top vent screw. fill/squeeze new oil into bottom screw until oil comes out vent screw..done !


How many threads are there on the average screw?

The average screw has only one thread which winds from top to bottom


Where is adjusting screw for headlight on 2005 ford taurus?

On the bottom.


What are the main parts of the screw?

Top and bottom and sharp bit


How do you bleed the cooling system on a 2004 Chrysler PT Cruiser?

Engine off, remove radiator cap. Loosen blender screw below rad cap. Top off coolant infill it comes out of blender. Tighten blender. Instal cap, start engine and warm up. Then let it cool off and recheck fluid level.


What are the main parts of a screw?

The main parts of a screw include: Head: The top part of the screw that is usually slotted or Phillips-shaped for turning with a screwdriver or drill. Shank: The cylindrical body of the screw that has threads wrapped around it. Threads: The spiraled ridges on the shank that grip and secure materials when the screw is turned. Point: The sharp or tapered end of the screw that facilitates easy penetration into materials. Root: The bottom of the threads, where they meet the shank. Length: The measurement from the tip of the screw to the bottom of the head. These components work together to fasten materials by turning the screw into them