0
What is the maximum length allowed for a hot water draw off pipe pipe from a combination boiler to appliance or tap?
The maximum length allowed for a hot water draw-off pipe from a combination boiler to an appliance or tap typically depends on the specific manufacturer's guidelines and local Plumbing codes. Generally, it is recommended to keep the length under 15 meters (approximately 49 feet) to ensure adequate water temperature and pressure. However, for longer distances, additional considerations such as pipe diameter, insulation, and potential heat loss should be taken into account. Always refer to the boiler's installation manual and local regulations for precise requirements.
What else can I help you with?
What is bmcr in powerplant?
BMCR: Boiler Maximum Contininous Rating
If a boiler fails to light after numerous attemps would you say there is a underlined fault with the appliance and needs an engineer?
Yes
What is the maximum heat input from a gas burner on a fire tube boiler?
The maximum heat input is about 200 kelvin.
What is the allowed chloride content for a boiler water?
10 ppm
What is boiler trouble?
When your water heating appliance is not working like it was designed to do so because of a fault or action implemented upon it.
What is the highest pressure safety valve allowed on a low pressure boiler?
I believe that is 15 PSI on a low pressure steam boiler
What can an electric boiler be used for?
An electric water boiler is a small appliance used to boil water. This can then be used for hot drinks or in a recipe that requires boiling water. An electric boiler is also helpful if the water coming from the tap contains contaminants, because boiling the water will eliminate them.
What is boiler maximum continuous rating?
The boiler maximum continuous rating (MCR) refers to the maximum amount of steam or hot water that a boiler can produce continuously under standard operating conditions. It is typically expressed in terms of mass flow rate, such as kilograms per hour (kg/h) or pounds per hour (lb/h). The MCR is important for determining the boiler's capacity to meet demand and is a critical factor in system design and efficiency. Understanding the MCR helps ensure that the boiler operates within its safe and efficient limits.
What makes my hot boiler run an shut off then run an shut off?
When it achieves the maximum temperature, it shuts off. Then when there is demand for the water, or it is at its low setting, the boiler fires up again until it reaches the maximum temperature set.
A low pressure steam boiler has a maximum allowable working pressure of up to?
The maximum allowable working pressure for a low pressure steam boiler is typically up to 15 psi (pounds per square inch). This indicates the highest pressure level at which the boiler can operate safely without the risk of failure or damage. It is important to adhere to the manufacturer's specified limits to maintain the boiler's safety and functionality.
What are the average prices for boilers?
The average price range for a new boiler can be in the region of $500 for a small, occasional use boiler to $4000 for combination and energy efficient boiler.
What is the max pressure and capacity in fire tube boiler?
the maximum pressure and the capacity in the fire tube boiler are usually depends on the model design and specified by the manufacturers in the manufacturer manual.
