0
What else can I help you with?
What data is needed to fabricate a 16 inch pipe elbow?
hi need ur help 4 dis . What data is needed to fabricate a 16 inch pipe elbow?
Give formula of making pipe elbow for fabrication?
233
What is the formula of 45degee elbow?
.625'' x pipe diameter
What is the formula 45 degree elbow?
15.875 x pipe size=
Do you have a formula for pipe cut piece to 90 degree elbow?
Yes, to calculate the length of pipe needed for a 90-degree elbow, you can use the formula: Length = (Distance from the center of the elbow to the center of the next fitting) - (Radius of the elbow). The radius is typically specified by the elbow type (e.g., short or long radius). Additionally, consider any allowances for fitting tolerances when cutting the pipe.
What is the formula to find take off for 30degree elbow?
The take-off for a 30-degree elbow can be calculated using the formula: Take-off = Pipe Diameter × 0.577. For example, if the pipe diameter is 4 inches, the take-off would be 4 × 0.577 = 2.308 inches. This formula helps determine the horizontal run of the pipe after the elbow joint.
What is the take off formula off 45 degree elbow pipe?
The take off formula of a 45 degree elbow pipe, will depend on what the pipe is on. Sometimes a 45 degree pipe will need a 90 degree right angle turn to come off.
What is the take out for a 4 long radius degree weld ell?
The take-out for a 4-inch long radius degree weld elbow (or ell) is typically determined by the radius of the elbow and the pipe diameter. For a long radius elbow, the centerline radius is usually 1.5 times the pipe diameter; therefore, for a 4-inch diameter pipe, the centerline radius would be 6 inches. The take-out length is generally the distance from the end of the pipe to the point where the elbow connects, which can be calculated based on the elbow's radius and the angle of the bend. For a 90-degree elbow, the take-out would be approximately equal to the radius plus the straight length of the pipe before and after the elbow, typically resulting in about 9 to 10 inches.
What is the formula of takes off for 30 degree pipe elbow?
this app help you: "Miter Flat Pattern Design" in play.google.com
What is the formula for determining the takeout of a 45 degree Elbow?
5/8 x pipe size
What is the formula of 90 elbow?
Radius=C=1.5*NPS nps=nominal pipe size
How do you calculate surface area of pipe elbow?
(Pi*(Center of elbow - od/2)^2-(pi*(Center of elbow+od/2)^2)÷4)÷100000=0.221 Square Meter
