no.....thermistors are not ohmic.
ohmic conductor does obey ohm 's law. non ohmic conductor does not obey ohm's law.
which law follow non ohmic substances
A non-ohmic resistor doesn't have a constant resistance. A ohmic resistor has a constant resistance.
iron,gold
ohmic conductors are those which obey ohm's law
An 'ohmic' resistor is one which obeys Ohm's Law. For Ohm's Law to apply, the resistance of a circuit must be constant over the range of incremental voltages applied to it. If the resistance changes over an incremental range of voltages, then it is said to be 'non-ohmic', and it does not obey Ohm's Law.
Vacuum tubes are non-ohmic devices because their resistance changes with voltage and current. This non-linearity in resistance is due to the nature of the electron flow within the vacuum tube, causing it to exhibit non-ohmic behavior.
In the open circuit test, the voltage applied to the transformer is at its rated value with no load (open terminals), resulting in minimal current flowing through the windings. As a result, the copper losses (ohmic losses) in the windings are negligible since the current is minimal. The main power loss in this test is from core losses due to hysteresis and eddy currents in the core material, which are much larger than the ohmic losses when the transformer is under load.
ohmic ocnductor is a material which obeys ohm's law: i.e. the voltage and current are directly proportional 2 each other anda non-ohmic ocnductor is a material which doesn't obey ohm's law:)
A three phase induction machine have the Following losses:- 1. Stator core loss 2.Stator Ohmic loss 3.Rotor core loss 4.Rotor ohmic loss 5.Friction losses 6.windage losses 7.Stray losses 8.Also it'll depends upon the types of motor as if it is a slip ring type IM then it will have sparking losses at slip contact etc etc which are very small in comparison to above losses. Regards,,
current doublesAnswerIt depends on whether the wire is ohmic or non-ohmic. If it is ohmic, then the current will also double. If, like tungsten, it is non-ohmic, then it depends.... because doubling the voltage will cause its resistance to increase.Ohmic materials obey Ohm's Law, whereas non-ohmic materials do not.