answersLogoWhite

0

What else can I help you with?

Related Questions

Before you begin fueling your vessel what should be within reach?

Before you begin fueling your boat, you should make sure your fire extinguisher is within reach. This is a basic safety precaution. It is also best to fuel your boat on a ramp rather than in the water.


How were the Hopi govnered?

They were governed from there meat and fur and fire and it will stand before them


When using an extinguisher you should?

Stand 8-10 feet away from the fire


Why should you not stand too close to a bonfire?

you will get overheated/catch on fire/die


What does piggies say they should have done before starting a fire?

He said they should have lit the fire on the beach.


What does piggy say they should have done before starting fire?

He said they should have lit the fire on the beach.


What are the safety precautions to consider when using a Dutch oven fire stand?

When using a Dutch oven fire stand, it is important to consider the following safety precautions: Place the fire stand on a stable and level surface away from any flammable materials. Use heat-resistant gloves when handling the Dutch oven or fire stand. Keep a fire extinguisher or water source nearby in case of emergencies. Never leave the fire unattended and always supervise children and pets around the fire stand. Allow the Dutch oven and fire stand to cool completely before handling or storing them.


When was Stand in the Fire created?

Stand in the Fire was created in 1981.


How to use smoker grills properly?

You should always clean your grills before you begin any grilling. Have fire and coal ready. Make sure you check all settings are at the appropriate range for your food.


Where did fire fighting begin?

when a fire started


What should be considered before attempting fire building?

—Before building a fire you should figure out what kinds of tequneqies you are going to use to light the fire and where the best place possible is .—When trying to build a fire try and find a spot that is not too close to the water (as your water might wash your fire out)


In timing a car what does bdtc stand for?

Before Top Dead Center. Rotate the crankshaft so that the #1 piston is exactly at the top of its stroke as seen through open spark plug hole. This is Top Dead Center. Then make a mark on the flywheel or harmonic balancer relative to a convenient reference point. Typically the breaker points should just begin to open and/or the the spark plug for the #1 cylinder should fire when this mark is the specified number of degrees before this point when the engine is turned in the normal direction of rotation.