0
What else can I help you with?
What are the side effects on amp amplified mass xxx?
Can taking amplified mass xxx cause cancer
How shall you connect pedal effects to a fender amplifier with send in send out jacks?
The send out of the amp to the in of the effects, the out of the effects to the send in of the amp.
What does it mean to have a wet or dry sounding amp?
Wet means the amp sound has effects, while dry is no effects.
Are there side effects for GNC pro performance amp amplified endurance booster?
Yes. It gives you endurance that can make you like Superman.
How can I incorporate an effects loop into my amp if it does not already have one?
To incorporate an effects loop into your amp if it does not already have one, you can consult a professional technician or purchase an external effects loop pedal that can be connected between your guitar and the amp. This will allow you to add effects pedals into the signal chain without altering the amp itself.
Which line 6 amp has a effects loop?
Line 6 Jam amp
Can you get a bladder infection from drinking amp?
It is very much unlikely.
How many effects does a fender bullet 150 DSP amp have?
15 effects
How do I connect a multi-effects pedal to an amp?
To connect a multi-effects pedal to an amp, you will need two instrument cables. First, plug one cable from your guitar into the input of the multi-effects pedal. Then, connect the output of the pedal to the input of the amp using the second cable. Make sure to set the pedal and amp to the desired settings and levels for your sound.
How does send and return work on a guitar amp?
Send and return on a guitar amp refers to an effects loop that allows you to integrate external effects processors between the preamp and power amp sections. The "send" jack sends the signal from the preamp out to the effects unit, while the "return" jack brings the processed signal back into the amp before it reaches the power section. This setup preserves the tonal integrity of the guitar signal and allows for greater flexibility in effects placement, particularly for time-based effects like reverb and delay.
How do you connect your speakers and sub to your amp?
You connect speakers and a sub to an amp by placing each wire into the appropriate connector. The connectors on the side of the amp are labelled for front, back, side, and sub depending on the configuration.
Where does the pedal go in the amp?
Gain effects lie overdrive, compressor etc go between the guitar and amp, time based effect eg flange, chorus go in the effects loop.
