A Niskin bottle is a type of water sampling device used in oceanography to collect water samples at various depths in a body of water. It is typically a cylindrical, closed bottle with a mechanism that allows it to be opened and closed remotely, often triggered by a weight drop or electronic signal. When deployed from a research vessel, it can capture water at specific depths, helping scientists analyze temperature, salinity, and chemical composition. Niskin bottles are crucial for studying marine environments and understanding oceanic processes.
Borghild Niskin was born in 1924.
A Niskin bottle is commonly used to collect water samples from different depths in bodies of water. It is a cylindrical, free-flowing tube that can be triggered to close at specific depths, capturing the water sample within the container for analysis.
If you think about it for a moment, depth is a measure of length, so of the four units provided only miles and meters are used for length. Ounces and gallons are US measures of fluid capacity.
A Niskin water sampler is used to collect water samples at specific depths in the ocean without contamination or loss of dissolved gases. It consists of two tubes connected by a spring-loaded closure, allowing the sampler to capture a "clean" sample of water at a desired depth by remotely closing the device. This is crucial for studying the distribution of nutrients, pollutants, and plankton in the ocean.
Fill Bottle 7 . . . then use bottle 7 to fill bottle 5 . . Empty bottle 5 and put the remaining two litres from bottle 7 into bottle 5 . . Fill bottle 7 then use bottle 7 to fill bottle 5 . . empty bottle 5 . . Fill bottle 5 with the remaining 4 litres in bottle 7 . . fill bottle 7 and then use bottle 7 to fill bottle 5 . . this will leave you with 6 litres in bottle 7 . . Done
Fill the 5l bottle Pour the 5l into the 7l bottle Fill the 5l bottle Pour 2l from the 5l bottle to the 7l bottle, leaving 3l in the 5l bottle Empty the 7l bottle Pour the 3l into the 7l bottle Fill the 5l bottle Pour the 5l into the 7l bottle leaving 1l in the 5 ll bottle Empty the 7l bottle Pour the 1l into the 7l bottle Fill the 5l bottle Pour the 5l bottle in the 7l bottle which makes 6l in the 7l bottle! Hard work for just 6l!
an empty water bottle
i drank out of the bottle. there was a broken bottle on the ground. the baby drank out of her bottle. i opened the bottle. hope that helps :)
The plural of bottle top is bottle tops. As in "the bottle tops are plastic".
Push the cork into the bottle.
jack is short for Jack Daniels, so a bottle of jack is a bottle of Jack Daniels
If the bottles are identical, then the bottle of waterhasmore mass in it than the bottle of steam.