It depends on the situation and the type of iron it is. The other things mixed with the iron, such as carbon, oxygen and other trace metals and minerals can have a big effect on whether it will bend.
Cast iron tends to be fairly brittle and doesn't bend well. But if you heat it, it bends fairly easily. Other types of iron can be bent and curved with a little bit of effort.
Most times, iron is not bendy. If you heat up iron at every extreme temps, it may be able to bend with special tools.
Elements in Group I and II can easily bend, but cannot breakdown easily. So as Mg is in Group II, it can bend easily but does not break easily.
A Syncline is where lays of rock bend downwards and then curve up. An Anticline is the opposite: layers of rock bend upwards and then down.
yes
Iron Ore is an Iron Compound. Iron ore is usually used to make pig iron(metallic iron), cast iron, corrugated iron structural sheeting, and wrought iron.
an iron bar is harder to bend.
You can get a manual for a West Bend cordless iron is from the website, foxy. You can also get a manual from laundry.manualsonline.
It is a physical change.
no it is not flexible but when you melt it then you cn bend it but not much.
Most times, iron is not bendy. If you heat up iron at every extreme temps, it may be able to bend with special tools.
Do they do they bend thiner or thicker
Iron is one of the metals of which can be saturated with carbon. It is commonly used to make Iron harder. Unfortunately it will also make the Iron brittle. Iron with a lot of carbon in it can break and shatter if hit hard. Iron without carbon is "soft" and will most likely only bend.
I didn't watch it. Can you tell me?
"Strike while the iron is hot" is an idiom that means to take advantage of an opportunity when it presents itself, rather than waiting. The phrase originates from blacksmithing, where iron is easier to shape and mold when it's hot. It emphasizes the importance of acting promptly and decisively to capitalize on favorable conditions.
That's a physical change. Assuming the nail is made of iron (Fe), when you bend it, you simply change its shape. You don't change the fact that it's still iron.
yes i think so because if you had a iron bracelet and a sliver bracelet you could easily bend the sliver more then the iron.also you have learned 2 things buy iron bracelet because they don't break as fast and the iron is stronger then sliverhope uv learned somethingpeace outlol
The heat WILL melt the glue, it has to or the laminate wouldn't bend properly. The trick is to not let the heat get too hot, and to keep the wood in a 'former' until it completely cools and the glue re-sets. - I have done this in the past, but not with an iron. I found more success with a commercial 'heat ribbon' that you can buy at plexiglass stores for bending plexiglass and other rigid plastics.