NH4Cl - Ammonium Chloride
Sand is usually placed at the bottom of a soil and sand bottle because it is the heaviest material and helps with drainage. Placing sand at the bottom allows for better aeration and prevents waterlogging of the soil above.
Iron oxide is only soluble when placed in concentrated mineral acids. It is insoluble in organic and water based solvents.
Leaving a bottle of water in the freezer and then taking it out to thaw at room temperature is an example of freeze-thaw process. The water freezes when placed in the freezer and then thaws when taken out, transitioning between solid and liquid states.
There are six correctly placed plates in the set.
yes. Over very long periods of time, soils build up. They are eventually submerged by younger soils. When enough is built up, the lower soils are placed under ever increasing weight and pressure. Eventually, that heat and pressure recrystallize the soil constituents and rock is formed. This final process of forming rock is called lithification.
when raisins are placed in concentrated solution of sugarthen they will swell up
When placed in a hypertonic solution, an amoeba will lose water to the surrounding environment through osmosis. This loss of water causes the cell to shrink and may eventually lead to dehydration and cell death if the solution is highly concentrated.
When the bottle is placed in hot water, the air inside expands due to the increased temperature. This causes the balloon to inflate as the air pressure inside the bottle increases.
If the cover of a reagent bottle is placed on a table with the bottom down, it can pick up material from the table which would contaminate the contents of the reagent bottle after the cap is put back on the bottle.
Different things can happen if a bottle is placed gently on flour. If the flour is all spread out on a counter, then the bottle will leave prints in the flour. If the flour is packed tightly, then it is possible for the flour to be able to hold up the bottle.
fixed or organized or placed concentrated, condensed, gathered, organized
When the bottle was placed in cold water, the air inside the bottle cooled down and contracted, causing the bubble to shrink or collapse. The decrease in temperature led to a decrease in the volume of air in the bottle, making the bubble appear smaller or disappear.
Yes, a pipet can be placed in a reagent bottle to withdraw specific volumes of the reagent as needed. It is important to ensure that the pipet tip does not touch the sides or bottom of the bottle to prevent contamination and maintain accuracy in volume measurement.
While the pear is small it is placed in the bottle, and the bottle is supported in the tree. Pear reaches full size in the bottle.
the heater is placed in the 8 corners
When a bottle-and-balloon system is placed in hot water, the air inside the bottle expands due to an increase in temperature. Since the bottle is sealed off from the outside, the expanding air has nowhere to go, causing the balloon to inflate as a result of the increased pressure inside the bottle.
Yes as long as it is smooth and has no residue on the surface.