116
When a paracel of air is cooled to the temperature at which it is saturated, it has reached its dew point.
The process is called condensation. It occurs when the water is cooled below its boiling point due to the temperature in the environment cooling it.
Hydrogen, helium, nitrogen, oxygen, fluorine, neon, chlorine, argon, bromine, krypton, xenon and radon are all gases at 100 deg C. Only Bromine will condense if cooled to room temperature.
Stays nearly the same but the surface temperature
The dewpoint is the temperature to which the air must be cooled to become saturated. A lower dewpoint, as in winter, indicates there is less moisture in the air, so the air must be cooled farther before it will become saturated with water. Dewpoint is a combination of many factors, including temperature, humidity, and pressure.
The room temperature water in the hot beaker turns into hot water (not boiling) if the beaker is hot enough.
A glass beaker is completely filled with 456 c.c. of a liquid when both the glass beaker and the liquid are at a temperature of 33.3oC. If the glass beaker and the liquid are cooled to 5oC. what additional volume of liquid (in c.c.) can be put into the beaker?Volumetric coefficient of expansion of liquid is 0.000109K-1 and the coefficient of linear expansion for glass is 3.2X10-6K-1
When a paracel of air is cooled to the temperature at which it is saturated, it has reached its dew point.
No. They can be heated or cooled.
Pasteurization (preservation by moderate heating) more especially LTLT = low temperature - long time.
Yes the word cooled is a verb. It is also an adjective to describe something at a lower temperature.
Natural gas is compressed when it is cooled. When cooled to a temperature of -162 Degrees, it becomes liquid.
10 minutes
it can be as hot as 1,750 degrees faernheit
Water can be evaporated at any temperature.
The temperature to which air must be cooled to reach saturation is called the dew point.
This is a method of exaust dyeing in which fabric is first taken to 80 degree centigrade in the presence of dye and salt only. After 20 minutes the temperature is cooled down to 60 degree centigrade and then after 10-20 minutes at this temperature the sodium carbonate is added and given 30 minutes furhter. Sharj33l Textile Engineer,Faisalabad, Pakistan sharj33l_abid@hotmail.com