This means that for every volume of hydrogen peroxide used, 20 volumes of oxygen will be produced. For example, if 1 ml of hydrogen peroxide is used/decomposes, 20 ml of oxygen will be formed.
The strength of a solution may be described as a percentage or volume, where 1% hydrogen peroxide releases 3.3 volumes of oxygen during decomposition.Thus, a 3% solution is equivalent to 10 volume and a 6% solution to 20 volume, etc. Answer taken from Wikipedia 19/01/2009
To dilute 20 volume hydrogen peroxide to make a 3% solution, mix 1 part of 20 volume hydrogen peroxide with about 6 parts water. This will result in a 3% concentration of hydrogen peroxide. Remember to handle hydrogen peroxide carefully and wear appropriate protective gear.
20 volume peroxide comes from a beauty supply store. Try Sally's.
Get the peroxide bottle and put the contents of it into a spray bottle. DONT MIX THE PEROXIDE WITH WATER OR LEMON JUICE IT WILL MISS UP THE STRENGTH OF THE PEROXIDE. Spray the peroxide on your hair. Let it dry. You can also go under the blow dryer and it will change colors.**If you go into the sun it will get lighter immediately**
To make a 20 vol peroxide solution from a 40 vol peroxide solution, you need to dilute the 40 vol solution by mixing it with an equal amount of water. This will effectively reduce the concentration of the peroxide solution by half, resulting in a 20 vol solution.
The strength of a solution may be described as a percentage or volume, where 1% hydrogen peroxide releases 3.3 volumes of oxygen during decomposition.Thus, a 3% solution is equivalent to 10 volume and a 6% solution to 20 volume, etc. Answer taken from Wikipedia 19/01/2009
Yes
To dilute 20 volume hydrogen peroxide to make a 3% solution, mix 1 part of 20 volume hydrogen peroxide with about 6 parts water. This will result in a 3% concentration of hydrogen peroxide. Remember to handle hydrogen peroxide carefully and wear appropriate protective gear.
Pure hydrogen peroxide has a density of 1.450g/cm3 at 20 oC. (Wikipedia)
20 volume peroxide comes from a beauty supply store. Try Sally's.
At least a 20 Volume, 6% peroxide should be used for lifting. Although, the hair tone can still be changed with 10 Volume, 3%. Using this however, you will not see much lift.
try hydrogen peroxide and shampoo mixed for 20 mins or dishwash soap
Yes, you can use hydrogen peroxide to whiten dentures. However, it is important to dilute the hydrogen peroxide with water (1:1 ratio) before soaking the dentures in the solution for 20-30 minutes. It is recommended to rinse the dentures thoroughly with water after soaking to remove any residue before wearing them again.
Volume is the amount of oxygen that is contained in a given amount of peroxide. For example, 3% hydrogen peroxide is V10 or 10 volume, because it will release 10 times it's volume in oxygen. One pint of 3% hydrogen peroxide will release 10 pints of oxygen as it breaks down. Gee, now there is something to think about. Of course, V20 will release twice as much oxygen, 20 times its volume.
No, 20 volume hydrogen peroxide is a higher concentration typically used in hair coloring and lightening products sold in beauty supply stores. Hair salons usually use lower concentrations for safer use on the hair.
To make a 40-volume developer, you would mix equal parts of 20-volume (6%) hydrogen peroxide cream developer with another equal part of 20-volume (6%) hydrogen peroxide cream developer. This will give you a total volume of 40 (12%).
Get the peroxide bottle and put the contents of it into a spray bottle. DONT MIX THE PEROXIDE WITH WATER OR LEMON JUICE IT WILL MISS UP THE STRENGTH OF THE PEROXIDE. Spray the peroxide on your hair. Let it dry. You can also go under the blow dryer and it will change colors.**If you go into the sun it will get lighter immediately**