Where is the temperature sensor located on a 2004 duramax diesel?
Yes they are the same, now-a-days it is called IAT (Inlet Air Temperature)
linear monolithic
On the 1.6 Zetec it's actually on the back of the EFI manifold, and it screws in. A 24mm spanner can be used to remove it (or mole grips).
Check to see if the fixture has a sensitivity setting or switch. Perhaps it needs to be adjusted or set correctly? I'm looking for the proper settings for mine now. Here is THE ANSWER: The photo cell that senses light and darkness is sensing the light coming from the fixture being controlled. Reposition the sensor away from the light of the fixture. Or shield the sensor from the light. Ideally the sensor should be located away from the light source.
well, in our case, I suspect it reflects the fact that the outside sensor was encased in ice during our recent weather & has now snapped off. Indoor reading still fine.
on the intake manifold near housing
On intake manifold behind ac compressor
Store under the drain pan of the transmission.
where is the crank sensor located on a 6.0l ford power stroke diesel
The Duramax don't have a knock sensor.
In the transmission cooler line. Two wire connector
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
transmission temperature sensor location
The ambient air temperature sensor, on a Caterpillar see 13 diesel engine, is located between the air filter and the air intake on the engine. The sensor should be near the air filter.
The ambient temperature sensor is located behind the front grill.
under the back-right suppertronic convention metre
Where is the temperature cooling sensor located