0
What else can I help you with?
How do you replace passenger mirror on 1996 Saturn?
You first need to remove the triangle shaped trim piece inside the door opposite the mirror. It just pries out with a screwdriver. Then disconnect the electrical connections if a powered mirror. Undo the 3 bolts holding it and then remove the mirror. -RC-
1996 Saturn cigarette lighter fuse?
Located in the passenger side kick panel
How do you remove the power mirror control switch on a 1996 Toyota Camry?
How much does it cost to replace a passenger side mirror on a 1996 Camary. The whole Mirror broke off. Answer I don't know how to fix one. I wish I did, I think I am going to have to buy one.
What is the spark plug wire order on a 1996 Saturn SL?
1-3-4-2 No. 1 closest to passenger side
How do you change passenger side mirror on 1996 gmc safari?
remove interior left corner cap--then remove 3 screws and then remove mirror--->reverse procedure to put back new mirror...u r almost a technician
Selling price of a 1996 Saturn?
Selling price of a 1996 Saturn?
Where Is The Low Pressure Side Valve On 1996 Saturn SC1?
Larger hose from a/c compressor may be near the drier on the passenger side firewall
What are the procedures to replace a passenger side mirror on a 1996 Chevy S-10?
Go to this website. It will show to take off the door panel and the side mirror. http://www.kwmuth.com/techsupport/pdfs/21000170.pdf
Does the 1996 Saturn SL2 fender fit the 1996 Saturn SC2?
NOT AT ALL
1996 Saturn what refrigerant should you use?
A 1996 Saturn vehicle will only use R134A refrigerant. I was a Saturn technician for years in Saturn Dealerships.
How do you fix a passenger side mirror on a 1996 Chevy s10?
Remove the inside door panel. There are three bolts with nuts & washers that hold the mirror onto the truck. If your windows are manual, the crank level will need to be removed.
How do you install a passenger side mirror in a 1996 Oldsmobile Aurora?
Remove the door panel. Towards the front of the door there are two screws holding the mirror on. Inside the door are two connectors that connect the mirror wires to the door. I have a 98 and if it is the same process that's all you need to do.
