To change the key tumbler on a 2000 Saturn, first, remove the ignition cylinder by disconnecting the battery and taking out the steering column covers. Then, insert the key and turn it to the "Run" position while pressing the release pin on the ignition cylinder. Once removed, you can replace the old tumbler with a new one, ensuring it aligns correctly with the new key. Finally, reassemble the ignition cylinder and steering column covers, and reconnect the battery.
Remove the inside door panel. Remove the linkage from the key tumbler. Remove the key tumbler retaining nut. Reverse the process to install the new key tumbler.
Yes, but if the key is changed or replacement key is cut it must be reprogrammed. The tumbler from Ford comes with "gates" to rekey the tumbler to the original key.
It helps to know which key tumbler you're talking about. The one for the ignition won't be the same process as the one for the cab doors.
Locksmith or replace locks
Do you want the ignition switch or the key tumbler?
Remove the retaining ring from the top of your 1977 Chevrolet pickup truck ignition key tumbler. Slide the ignition key tumbler out. Remove the wiring harness from the end of the key tumbler.
The 2000 Saturn LS1 valet key will start the car. It is made to open the driver's side door and start the car.
To change the key and tumbler in a 2001 GMC Jimmy, first, ensure the ignition is in the OFF position and disconnect the battery. Remove the steering column covers to access the ignition switch. Use a small tool to press the pin on the switch and turn the key to the "Run" position to release the tumbler. Once removed, install the new tumbler by aligning it and locking it in place before reassembling the steering column and reconnecting the battery.
First get a new key from the dealer. Do not make a copy of it from the local hardware store. The dealer cuts it to the VIN.
USUALLY the key and tumbler in this model is held in by a supporting pin on the front or the back of the key and tumbler. Push the pin in with a small screwdriver or an awl. the pull it out. Put the new key and tumbler in the same way push it in until the pin locks in place then turn the key to see if it works. If it works you are finished!!
When you say key tumbler, are you referring to thr ign key cylinder, door , glove box or trunk cylinder. All tricky, most difficult--steering col lock cylinder. Steering wheel, signal switch, must come off.
The pin is on the bottom of cylinder, push it while turning the key until it goes in all the way and then pull the ignition out.