Well, when you've finished changing the coolant on your 2006 Saturn Vue and you notice the light is still on, don't worry, it just needs a little reset. Simply locate the fuse box under the hood, find the fuse labeled "ECM" or "ECU," remove it for about 30 seconds, then put it back in. This should reset the light and your Saturn Vue will be back to shining bright in no time.
fill the coolant reserve and the light should go out
Fill your coolant to the level that it should be at. If it still comes on when the coolant is at its proper area, then it is an improper sensor. You will need to have it replaced immediately to reset the sensor.
There is no way to reset the light. If the light is on, then either the coolant is low, the float is stuck or the sensor is bad.
Nothing to reset except the radio presets and the clock.
I have a 2007 and I have to push the trip button until the oil life indicator shows. Once it does I have to push and hold the button until it says reset.
Well, it will no light up if you have the correct coolant levels.
You should be able to reset the low coolant light by the parking light switch 3 times on and off somewhat quickly should do it
there is no reset you have replace the low coolant sensor and flush cooling system and use dexcool coolant.
To reset the low coolant light in a 2000 Silhouette, first ensure that the coolant level is topped off in the reservoir. Next, turn on the ignition without starting the engine, allowing the dashboard lights to illuminate. Once the low coolant light is on, press the gas pedal three times within five seconds to reset the warning light. Finally, start the engine to confirm the light has been reset.
To reset your 2007 Saturn Vue after changing the battery, you may need to reset the clock and radio presets. Additionally, to clear any error codes, you can disconnect the battery again for a few minutes and then reconnect it. If the check engine light is on, you might need an OBD-II scanner to reset it. Finally, drive the vehicle for a short distance to allow the engine control module to recalibrate.
its useful to add fluid to the radiator and itll reset itself ,,,,,,,,, check coolant temp sensor.
you may need to replace the sensor for the coolant, there should be a wire connected to it.