answersLogoWhite

0

Always use co-ax connectors if you possibly can. Co-ax is manufactured to have certain electrical charactersitics and the connectors are designed to retain those characteristics thought the length of the connection. Ideally, BNC connectors should be the first choice but there are several others that can be used. Most co-ax connectors need specialist tools to make off, but there are some screw on BNC connectors available that can be used without the specialist crimping tools normally used. If the cables are connected with the wrong connectors or by being twisted together, then the signal will be adversely affected. How bad the effect is dependent on the length of the cables and how bad a job of splicing has been done. It might be as little as a faint ghost image that isn't noiceable or it could be enough to completely corrupt a signal.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How can one extend a coax cable without special tools?

To extend a coax cable without special tools you will need a second coax cable. You can plug the second coax cable into the end of the first one (the end that is plugged into the wall).


Which RG rating of coax is used for cable modems?

Cable modems use RG-6 coax cables.


How long does it take to splice a cable?

It depends on how many wires are in the cable. The more conductors in the cable set the longer it will take to splice them.


How can I use a multimeter to test if a coax cable is live?

To test if a coax cable is live using a multimeter, set the multimeter to the continuity or resistance mode. Touch one probe to the center conductor of the coax cable and the other probe to the outer shield. If the multimeter shows a reading, the coax cable is live.


How can I test if a coax cable is live?

To test if a coax cable is live, you can use a cable tester or a multimeter to check for electrical continuity. Simply connect the tester or multimeter to both ends of the coax cable and look for a reading to determine if there is a live signal passing through the cable.


How can I test the signal of a coax cable?

To test the signal of a coax cable, you can use a cable tester or a multimeter. Connect the tester to both ends of the coax cable and check for continuity and signal strength. Look for any breaks or interference in the signal to determine if the cable is functioning properly.


What cable does Antietam cable uses to connect to the internet?

coax.


How to test coax cable for signal?

To test coax cable for signal, you can use a cable tester or a multimeter. Connect one end of the coax cable to the tester and the other end to the device you want to test. Check the tester or multimeter for a signal reading to determine if the cable is functioning properly.


What are the advantages of using wireless coax cable for data transmission compared to traditional wired coax cable?

Wireless coax cable offers the advantage of greater flexibility and mobility compared to traditional wired coax cable. It allows for easier installation and reconfiguration of networks without the need for physical cables. Additionally, wireless coax cable can provide faster data transmission speeds and reduce the risk of signal interference or degradation.


How can I test a coax cable without using a multimeter?

To test a coax cable without using a multimeter, you can use a cable tester specifically designed for coax cables. These testers can check for continuity and signal strength without the need for a multimeter.


How can I trace a coax cable to identify its path and connections?

To trace a coax cable and identify its path and connections, you can use a cable tracer tool. Connect one end of the tool to the coax cable and then use the receiver to follow the cable's path and locate its connections. The tool will emit a signal that can be detected along the cable, helping you trace it accurately.


Can you use any coax cable for satellite tv?

This would depend upon your TV and the receiver and if it has a coax port available on the back. You can use an RG6 coax cable between the receiver and TV. Most newer HD receivers do not have a coax port on the back