0
What else can I help you with?
How high should a shower head be to ride it?
I fit all shower heads 72 inches from floor .
What is the recommended height for a shower curb and how high should a shower curb be for optimal functionality and safety?
The recommended height for a shower curb is typically around 2 to 4 inches. This height allows for easy access into the shower while also providing a barrier to prevent water from spilling out. For optimal functionality and safety, the shower curb should be low enough to step over comfortably, but high enough to contain water within the shower area.
What causes a high pitch whine from the shower?
to much water flowing through shower valve will cause whistle in pipes.try a new shower head with less flow[gallons per minute]amount should be on head somewhere try 2.5 gpm or less
i have a 4'6''x4' shower with 8' ceilings and im enclosing with steam shower do i need to have a vent fan for this size area as a steam shower?
Yes, you should install a vent fan, to help keep mold, etc. under control.
Should you shower now or tomorrow?
Ideally, you should shower daily.
What shower head should I use if I have hard water?
High pressure shower heads will hold up best to hard water. However, regular cleaning is still advised.
How do you fix a leaking shower faucet from the wall?
If it is leaking from the control, you should be able to access that from the front. If it is the supply lines or the pipe to the shower head, there may be access behind it in a closet. If not, you just have to cut a hole to get to it.
What shower value should I use?
Depends what shower you have.
What parts do you need for shower control valves?
This depends on what exactly you want to control and where.
Should you shower after you eat?
No, You Should Actually Eat Before You Have A Shower, Better For Your Digestion.
How high to mount a shower head?
I mount them 70 inches from the floor of the shower.
Having trouble sweating the shower joint in a temptrol shower valve?
You have the guts out of the control correct? Re clean the parts, flux and heat the body of the control.
