Routing means going from X->Y,route means only showing the direction that it as to goto X from Y.Routing protocols are configured on the global mobe.where as route protocols are configured on serial interfaces.
Routing protocols are used by routers (RIP, EIGRP, OSPF) Routed protocols are the actual protocols on the wire (TCP/IP)
Which two technologies can be used in distance vector routing protocols to prevent routing loops?
Distance vector protocols are routing protocols that use the distance and direction to a destination network to make routing decisions. Examples include RIP (Routing Information Protocol) and EIGRP (Enhanced Interior Gateway Routing Protocol). These protocols share routing information with neighboring routers and update their routing tables based on the information received.
Which two technologies can be used in distance vector routing protocols to prevent routing loops?
Interior routing protocols are used to communicate within a single autonomous system. Exterior routing protocols are used to communicate between multiple autonomous systems.
Distance vector protocols compute their routing tables before sending routing updates; link-state protocols do not.
Routing Information Protocol (RIP) and Interior Gateway Routing Protocol (IGRP) are two very popular Distance Vector routing protocols
Multiple IP addresses..., Routing protocols must base...., Routing protocols must carry...
RIPv2 and EIGRP
A routing protocol is a formula that specifies how routers are communicating to each others. Types of routing protocols include Interior Gateway Protocol, Distance vector protocol and Classful or classless protocol. Routing protocols are required to determine the appropriate paths for data transmission.
The command used to display the commands that configure the routing protocol on a router is show running-config. This command provides a comprehensive view of the current configuration, including any routing protocols like OSPF, EIGRP, or BGP. To focus specifically on routing protocols, you can also use show ip protocols, which summarizes the active routing protocols and their settings.
Distance vector protocols exchange their routing tables, and add a metric to each route. Link-state routing protols exchange topology information, then calculate the routes. As a result, there are the following fundamental differences:The information that is exchanged - routing table vs. topology information.Link-state protocols know the topology of the network (or an area); distance vector routing protocols don't.When the best route is calculated: in distance-vector routing protocols, a metric is added while the route is propagated from router to router. In link-state protocols, the best route is calculated separately by each router, only after having complete topology information.