To calculate the general lighting load for a school using the National Electrical Code (NEC), you typically use 3 watts per square foot for classrooms and similar spaces. For a school of 212' by 235', the total area is 49,770 square feet, resulting in a general lighting load of approximately 149,310 watts (or 149.31 kW). Additionally, for receptacles, the NEC allows for 180 VA per receptacle, leading to an additional load of about 28,260 VA (or 28.26 kW) for 157 receptacles. The total calculated load would then be the sum of these two components, equating to approximately 177.57 kW.
There must be leakage current in the down stream receptacles It is going to be a trial and error method of finding the leak. Remove the GFI and make a through connection to the downstream receptacles Now go to first receptacle and install the GFI. If it holds the fault is further down stream. Keep going down the line until you find the fault. When the GFI trips and won't reset it will be the up stream feeder. Check the feeder wire for cuts or scrapes in the insulation. Replace this feeder.
a bird feeder !!!!!!
Michael Richard Hackett has written: 'The effects of artificial lighting on feeder lamb performance' -- subject(s): Sheep, Feed utilization efficiency
EIRP= Power of transmitter(dbw) + Antenna Gain (dBi) - (Feeder Loss + Combiner Loss) Feeder Loss depends on operating frequency, type of feeder (coax, waveguide, ladder-line, etc.), and nominal frequency for which the feeder is designed.
A bull feeder is a feeder that is used for bulls to eat out of, like a trough or feed bunk.
A river feeder is known as a tributary.
Dog is fetcher and person is feeder
feeder cader
what do a feeder driver do at ups
I have no idea what a 'feeder' is.
is whiting a bottom feeder
are you in feeder cader post