answersLogoWhite

0

In a 1996 Saturn, the low coolant switch is typically located in the coolant reservoir tank. It is usually positioned near the bottom of the reservoir, where it can detect the coolant level. You may need to remove the reservoir to access the switch for inspection or replacement. Always refer to the vehicle's service manual for specific details and diagrams.

User Avatar

AnswerBot

11h ago

What else can I help you with?

Related Questions

1996 where is the ECT sensor Camry 1996?

The ECT or the Engine Coolant Temperature Sensor is a switch. This switch is located on the bottom of the radiator in the 1996 Camry.


Where is the neutral safety switch on a 1996 Saturn?

where do you install a neutral safety switch on a 1996 saturn


Where is the coolant temp sensor located 0n a 1996 infinite j30?

Coolant Temperature Sensor/Switch (For Computer) ECCS Component Parts Location


Where is the coolant temperature sensor on a 1996 Saturn SL2?

The sensor is threaded into the coolant passage in the back of the cylinder head.


What type of ac coolant is used on a 1996 Saturn SC1?

R-134a


Where is the Coolant Level Sensor on a 1996 Aurora?

Its located on the bottom of the coolant reservore.


Where is the emergency fuel cutoff switch on a 1996 Saturn SL2?

It does not have one.


Where is water pump located on a 1996 Saturn sl2?

The water pump on a 1996 Saturn sl2 is located in the engine compartment. It sits below the AC compressor.


Where is the low coolant sensor located on a 1996 Chevy Cavalier?

Should be at the lower section of the coolant recovery tank


Where is fuel pressure regulator located on a 1996 Saturn?

Located on the fuel rail drivers side


Where is the thermostat located on a 1996 Saturn?

The thermostat is usually located on the lower hose, where it attaches to the radiator


Where is the relay switch located for wipers in a 1996 Saturn SL as the fuses are good?

the relay is part of the wiper motor assembly. if the fuses are good, and there is voltage at the motor, then you must replace the motor