0
What else can I help you with?
Location of starter on 2004 Chevy Silverado?
It is on the back lower left side of the engine While standing in the front of engine.
Do you check the transmission fluid in a Taurus with the engine on or off?
automatic....engine warm and running while in park, standard, engine off. But this is covered in your owner's manual
Locate the starter on a 1996 Chevy 1500 truck?
It will be on the left bottom side, towards the rear of the engine. while standing in front of the engine.
What is the automatic lubricator?
a automatic lubricator is a device fitted to asteam engine to supply lubricating oil to the cylinders and, sometimes, the bearingsas well.It's just a a automatic oil cup that oils locomotives while they're running....
Where is piston 1 located on a Lexus rx 300 engine?
Looking at the engine while standing at the front of the vehicle. The #1 cylinder is the back left corner.
What could be wrong with a automatic car that jolts while driving?
Could be anything from an engine management problem to the transmission failing
125 automatic stops running after mower has been running for a while?
Sounds like the engine heats and the ignition fails.
What does inhibitor switch do?
Inhibitor switch reduces engine power to avoid shock while automatic transmission changing gears
Dipstick on a Jeep Wrangler?
On an automatic transmission Jeep Wrangler there are two dipsticks. The engine oil dipstick is on the side of the motor, while the transmission dipstick is at the rear of the engine.
What kind of transmission is in a 04 Ford Explorer?
The 2004 Ford Explorer typically comes equipped with either a 5-speed automatic transmission (5R55E) or a 6-speed automatic transmission, depending on the engine configuration. The 4.0L V6 engine usually pairs with the 5-speed automatic, while the 4.6L V8 engine may utilize the 6-speed automatic. These transmissions are designed to provide a balance of performance and fuel efficiency for the vehicle.
Does engine need to running when checking transmission fluid for a 2000 v70 Volvo?
Yes it does. The proper way to check automatic transmission fluid is to check it while engine is at idle.
How do I test crankshaft position sensor on 2000 gmc safari van?
You would need to scope the signal, using a scanner tool with a scope function. With this you can look at the signal to the ECM while cranking the engine.
