Depending you the outboard make there is a bolt on the side of transom bracket just follow your trim line most times it's on the right side of your engine. hope this helps.
You have to remove the pull handle and take off the trim to access the actuator. There is a white plastic tab that can be moved to unlock manually. Hope this helps.
Probably not
Trim means to minutely adjust the fling control surfaces so the airplane keeps straight and level.
To adjust the work area in your project using the trim comp feature, you can trim the start or end point of a composition layer to change its duration. This allows you to modify the timing of your project without altering the content.
Yes
To manually trim the edges of your lawn, you can use a pair of garden shears or a manual lawn edger. Simply walk along the edge of your lawn and carefully trim away any overgrown grass or weeds to create a clean and neat border. Be sure to take your time and work slowly to achieve a precise and tidy result.
by using the sticks on the remote and adjust the trim
To trim in DaVinci Resolve 15, select the clip on the timeline, then use the trim tool to adjust the in and out points of the clip to the desired length. You can also use the trim buttons on the viewer to make precise adjustments.
you need to adjust the steering trim
when mine stuck, i climbed into the back removed the trim and manually pulled the release levers
Remove inner boot trim,locate solenoid pin,and pull back.
It should have disk brakes on the rear, no need to adjust. If you need to adjust the E-brake do it from the handle in the car (would need to remove trim to get to cable)